Once the camera is attached place the clip back on to the strap. When mounting to a tree, first remove the clip from one end of the strap so you can slide the strap through the slots located on the back of the camera. The highlighted option will be blinking.ġ. Press the enter navigation button while Image is selected. The time before the camera is able to take another picture. Press the enter navigation button to save the setting. Press the + or – navigation button to move to different options. The highlighted option will be blinking.Ģ. Press the enter navigation button while Delay is selected. Press the Enter navigation button to save the setting.ġ. Press the Enter navigation button while Exposure is selected. ![]() This is not a programmable mode for the camera.ġ. The number displayed is the number of photos on your SD card. Press and release the enter navigation button to choose Photos. When the Month is set, repeat steps 1 and 2 to set the Day and Year. Press the enter navigation button after setting the minute to change the Date.ģ. When the hour is set, repeat steps 1 and 2 to set the minutes.ġ. Press the + or – navigation button to go up or down in sequence.ģ. To change date and time, start by pressing and releasing the enter navigation button to set the hour.Ģ. After 2 minutes, all indicator lights will turn off until a button is pressed.ġ. After the LCD turns off, the red light will blink 2-3 seconds when photo is taken. LED Status Light: During the first 30 seconds of the LCD Ready Mode, the red light will illuminate when a PIR event is triggered. LCD Ready Mode: The camera will automatically enter Ready Mode if a button is not pressed for greater than 30 seconds.Ģ. The LCD will not “wake up” when camera is writing to memory. The LCD screen can be awakened by pressing the Power button briefly. After 30 seconds without any buttons being pushed, the LCD will turn off and camera enters into Power Save or Ready Mode.Ģ. To turn the unit off, first wake up the LCD screen and then depress and hold the power button until the LCD turns off.ġ. If so, you are ok to proceed with camera use.ġ. Check the battery level icon to ensure the batteries just installed contain the proper charge level. To turn the unit ON press and release the power button.Ģ. New cards are ok to use straight from the package. If you are using an SD card from other cameras, please make sure to format the SD card in your computer prior to use in your camera. Make sure the camera is powered off before removing or installing an SD card. Load SD memory card (up to 32GB) into the SD card slot with the connectors facing up. To latch the cover simply pull the latch slightly to the left as you close the battery compartment cover.ĥ. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nicad, ni-mh, etc) batteries.Ĥ.
0 Comments
Leave a Reply. |